Make sure the KOMPLETE AUDIO 6 is connected to your computer as described during the
installation chapter (chapter ↑2, Installing KOMPLETE AUDIO 6), and configured as your com-
puter's main audio output device (see chapter ↑3, Basic Configuration). See chapter ↑6.1,
Connecting Speakers for instructions on how to connect speakers (active and passive) to your
KOMPLETE AUDIO 6.
To use the KOMPLETE AUDIO 6 in a setup with typical line level equipment:
1. Turn the Volume Control knob (MAIN VOLUME 1/2) on the top panel of the KOMPLETE
AUDIO 6 to the left-end stop to set the volume to minimum.
2. Plug a pair of stereo 1/4" TRS cables from the outputs of your device into the inputs IN 3
and IN 4 on the rear panel of the KOMPLETE AUDIO 6 or unbalanced ¼” cable if you are
using a mono device.
3. Open the audio preferences of your audio recording software, and select the KOMPLETE
AUDIO 6 as your input and output device (you may have to restart your host software for
the changes to become active). Refer to the documentation of your audio recording soft-
ware for information on how to configure the audio device setup.
4. Adjust the output signal of your connected device by using the relevant volume/gain con-
trol. Check the KOMPLETE AUDIO 6's input LEDs (INPUT 3 and 4 on the top panel) to
make sure your input signal does not clip; adjust the device’s output level so that the
LEDs light green on input. A red lighting LED indicates signal clipping.
5. Gradually turn the Volume Control knob (MAIN VOLUME 1/2) on top of the KOMPLETE
AUDIO 6 to the right until you reach a good listening level.
Using the KOMPLETE AUDIO 6 (Setup Scenarios)
KOMPLETE AUDIO 6 in a Recording Setup
KOMPLETE AUDIO 6 - Manual - 44
To Next Page
Loading...
Need help?
General
