2. Attach a MIDI cable. One end goes to your MIDI controller's MIDI Out port, the other end
to the MIDI IN port of the KOMPLETE AUDIO 6.
3. If you are controlling an external synth: attach a MIDI cable, one end to your Synth’s MIDI
IN port, the other to the MIDI OUT port of the KOMPLETE AUDIO 6.
4. Open the audio and MIDI settings dialog of your digital audio workstation software and ac-
tivate the MIDI input and the MIDI output channel of your KOMPLETE AUDIO 6. For in-
formation on where to find the relevant dialog and how to apply the settings, please refer
to the documentation of your digital audio workstation software.
5. Gradually turn the Volume Control knob (MAIN VOLUME 1/2) on top of the KOMPLETE
AUDIO 6 to the right until you reach a good listening level.
To develop this setup further, you could now connect the synth's audio output to the
KOMPLETE AUDIO 6 and record the synthesizer with your digital audio workstation.
Using the KOMPLETE AUDIO 6 (Setup Scenarios)
KOMPLETE AUDIO 6 with MIDI Devices
KOMPLETE AUDIO 6 - Manual - 46
To Next Page
Loading...
