Software
1.
Click on the SLICE tab.
2. You can see that the Loop now has a couple of equally spread vertical lines in the
waveform: this is where the Slices are going to be applied. As we know the tempo is
identical to our Project tempo, click on AUTO in the Control Area; the BPM value will
remain unchanged.
3.
Next, select Detect in the Mode menu at the far left. This means that the Loop will be
sliced according to the transients detected in the Sample (in contrast to slicing it into
a specified number of Slices, or into Slices with a specified length). You will notice
that the vertical lines have snapped to the transients.
4.
Now click on the APPLY button to slice the selected Sample. Alternatively, click the
Slice Dragger and drag it onto another Sound or Group Slot:
Sampling
Slicing a Sample
MASCHINE - Getting Started - 90
To Next Page
Loading...
