natus Echo-Screen III Pro - Powering on and off and Logging in and off

© 2020 Natus Medical Incorporated 7 026057 RevE
Powering On and Off and Logging In and Off Echo-Screen III Pro Instructions for Use
IMPORTANT: Scan only barcodes supported by the device. If the barcode is too long, the
scanner cannot read it. Contact your administrator about supported barcodes.
Note: Data that is encoded in the barcode with uppercase letters appears in
the field as lowercase letters.
Powering On and Off and Logging In and Off
• To power on, briefly press the power button, and wait for the startup and splash screens.
The device starts in about a minute. Log in, if configured by your administrator. You may
need to enter a combination of user name, password, or location to log in.
• When powered on, press the power button briefly to go into or out of standby mode.
• To log off (if device is configured for logins), on the Home screen touch Log Off, or press
the power button to enter standby mode.
• To power down, press and hold the power button for several seconds. At the power off
prompt, touch OK.
• To force the device to shut down, press and hold the power button for about ten
seconds.
WARNING Although the barcode scanner uses an LED light and not a laser beam, do not direct
the barcode scanner light toward anyone’s eyes.