Nautilus E514c - Console Setup and Configuration; Setting Units and Machine Type; Console Settings and Logs

31
CONSOLE SETUp MOdE
The Console Setup Mode lets you set the units of measurement to either English or Metric, change the machine type, or see
maintenance statistics (Error Log and Run Hours – for service technician use only).
1. Hold down the Increase button and Decrease button together for 3 seconds while in the Power-Up Mode to go into the
Console Setup Mode.
Note: Push STOP to go back to the previous screen or the Power-Up Mode screen.
2. The Console display shows the Units prompt. Push START/ENTER to start Units option. Push the Increase/Decrease
buttonstochangebetween“Miles-Lb”(ImperialEnglishunits)and“Km-Kg”(metricunits).
Note: If the units change when there is data in User Statistics, the statistics convert to the new units.
3. PushSTART/ENTERtoset.Forthenextoption,pushtheIncreasebutton.
4. The Console display shows the Machine Type prompt. Push START/ENTER to start Machine Type option. Push the
Increase/DecreasebuttonstochangebetweenELLIPTICALandBIKE.
5. PushSTART/ENTERtoset.Forthenextoption,pushtheIncreasebutton.
6. The Console display shows the Brightness prompt. Push START/ENTER to start the brightness option. Push the
Increase/Decrease buttons to change the backlight levels from 1 (lowest) to 5 (highest).
7. PushSTART/ENTERtoset.Forthenextoption,pushtheIncreasebutton.
8. The Console display shows the Error Log prompt. Push START/ENTER to start Error Log option. The Error Log stores the
last 10 errors (error type and system time of error), listed newest to oldest. Push the Increase/Decrease buttons to move
throughtheErrorLog.Iftherearenoerrors,theConsoledisplayshows“Index=0”.
9. PushSTOPtoexit.Forthenextoption,pushtheIncreasebutton.
10. The Console shows the RUN HOURS prompt. Push START/ENTER to see total hours and minutes for the machine.
11. PushSTOPtoexit.Forthenextoption,pushtheIncreasebutton.
12. The Console display shows the Units prompt again. Push STOP to go back to the Power-Up Mode screen.