Navico Simrad RS100 - Mounting the BC-12 Wireless Handset Cradle

52 |
Installation | RS100 / RS100-B / V100 / V100-B User Manual
Mounting the BC-12 wireless handset cradle
¼ Notes:
• The BC-12 Wireless Handset Cradle requires a +12V DC supply for charging. Ensure the selected
location allows for the power wire at the rear of the unit.
• The handset LCD screen has an optimum horizontal and vertical viewing angles within approx.
+/-20 deg. Ensure the chosen location provides a suitable view of the display. Ideally, you should be
directly in front of the display or no more than +/-20 degrees from the front of the display.
1 Temporary place the handset cradle onto the chosen mounting location and mark the two mounting
screw holes.
2 Drill screw holes using a 3.0 mm (1/8” ) drill bit if using the supplied 4.0x25 mm self-tapping screws; or 4.1
mm (5/32”) drill bit if using the supplied 4.0x30 machine screws
Drill another hole (54.5 mm away from the middle hole) with a diameter of 3.6 mm for the charger
cable.
3 Attach the handset cradle to the mounting location using the provided screws.
4 Connect the BC-12 red wire (A) to battery (+) via 2A fuse (D) (not provided) and optional power switch (C).
Connect the black wire (B) to battery (-).
2
3
12V DC
A
B
C
D
4
54.5mm
1