Navico Simrad RS100 - Connector Pinouts; GND, Fuse, Power, and Speaker Connections; Handset and HS2-4 Connections

GND
12V DC
+ -
FUSE
S1+
S1-
S2+
S2-
S3+
S3-
S4+
S4-
MIC+
MIC-
PWR
PTT
TR-B
TR-A
GND
VCC
MIC+
MIC-
PWR
PTT
TR-B
TR-A
GND
VCC
RX_A
RX_B
TX_A
TX_B
HRN-
HRN+
SSW-
SSW+
PC
+ -
HAILER
SKP1-4
HS1
HS2
HS3
HS4
AUX
10 A
A
B
C D E F F F G
H
GND (A)
Optional ground connection. May help with induced noise issues. Ring terminal size M3, #5.
FUSE (B)
10 A mini-blade type fuse.
12V DC (C)
Vessels battery + and – power supply connection:
+ Red
Connect to vessel’s 12 V DC supply, via a switch
panel or breaker.
L1
- Black Connect to vessel’s DC supply negative.
SPK1 - 4 (D)
Wired Speakers SPK1-4. Connect (+) Red terminal to speaker (+) and (-) black to speaker (-):
S1+ RED External Speaker-1 (+) red wire
L2
S1- BLACK External Speaker-1 (-) black wire
S2+ RED External Speaker-2 (+) red wire
L3
S2- BLACK External Speaker-2 (-) black wire
S3+ RED External Speaker-3 (+) red wire
L4
S3- BLACK External Speaker-3 (-) black wire
S4+ RED External Speaker-4 (+) red wire
L5
S4- BLACK External Speaker-4 (-) black wire
HS1 (E)
Handset connection. HS1 is the main handset. All systems MUST have HS1 connected. The system can
only be turned ON or OFF via HS1; unless AUTO POWER is ON:
MIC+ WHITE Handset white wire
L6
MIC- GREY Handset grey wire
PWR ORANGE Handset orange wire
PTT GREEN Handset green wire
TR-B BLUE Handset blue wire
TR-A YELLOW Handset yellow wire
GND BLACK Handset black wire
VCC RED Handset red wire
HS2-4 (F)
HS2 additional fixed handset (optional). Same wiring as HS1 L7
HS3 additional fixed handset (optional). Same wiring as HS1 R6
HS4 additional fixed handset (optional). Same wiring as HS1 R7
58 |
Installation | RS100 / RS100-B / V100 / V100-B User Manual