BenchMike Pro Instruction Handbook: Installation 2-13
2.4 Adding a Network Printer
2.4.1 Requirements
The following requirements must be met to allow the BenchMike Pro to print to a network-attached printer:
• The BenchMike Pro must be able to access the printer via Ethernet.
• The operator must have a PC with a web browser attached to the same network as the BenchMike Pro.
• The target printer must be on the same network.
2.4.2 Procedure
1. Ensure an appropriate PC Network configuration, e.g., 10.32.0.60
2. Verify the IP configuration of the printer, e.g., 10.32.2.15
To Next Page
