BenchMike Pro Instruction Handbook: Setup 4-17
4.9 Reports
The key difference between Batch and Sample Reports is that Sample Reports can only be printed one time per
sample, while Batch Reports can be printed multiple times by pressing the Print key. Sample and Batch Reports
contain data from a single part measurement. If Continuous measurements are selected for Sample and Batch
Reports (under the Measurement Setup Type tab), measurements will be taken until the Print key is touched or
until the Reading Count equals the Batch Count value.
Fixture Sample and Fixture Batch Reports are generated when multiple measurements are made of one part, as
performed by a fixture. A Fixture Sample Report will print at the end of each part measurement cycle. A Fixture
Batch Report will print when the Batch Count equals the Part Count value or when the Print key is touched.
The following are samples of the four types of reports.
• The Sample and Batch Reports which follow are used when measuring samples with a V-Block or other
simple measurement fixture. They are printed after all measurements have been taken by touching Print.
• The Fixture Sample and Fixture Batch Reports shown can be created when either a manual fixture or an
intelligent fixture is used.
To Next Page
