Intercom Outgoing Call
28
Intercom Call
Intercom Call allows extension-to-extension conversation. The system can be programmed for one of two
Intercom Signaling modes: ringing or voice announce. When voice announce is programmed, an Intercom
call signals the called extension with a beep (not ringing). After the beep sounds, the caller can make a voice
announcement over the speaker of the called extension.
Regardless of the signaling mode programmed, an extension user can change it on a per call basis. For
example, a ringing Intercom call can be changed to a voice announced call by dialing a code.
1. Lift handset or press key.
2. Dial extension number.
- To convert a ringing call into a voice announced call,
or vice versa, dial 1.
1. Lift handset.
2. Dial extension number.
- To convert a ringing call into a voice announced call,
or vice versa, dial 1.
Note: Call Monitor, Speakerphone and Single Step Access provide ways to place Intercom Calls without lifting
the handset.
Direct Station Selection
Direct Station Selection (DSS) provides an extension user with one-button access to other extensions in the
system. Each of the ten One-Touch keys on a key telephone can be programmed to call a particular
extension. The One-Touch keys can also be programmed to access any Page Zone (see Paging) using the
steps below.
1. Lift handset.
2. Press key.
3. Press .
4. Dial .
5. Press key.
6. Dial extension number.
or
to program a Page Zone, dial 80 - 85.
to program a Doorphone, dial 88 or 89.
7. To program more keys, repeat steps 3-6.
8. Hang up.
1. Lift handset. If Single Step Access is programmed and the
phone is equipped with a Speakerphone, this step can be
skipped.
2. Press key set as DSS key.
To place an Intercom Call:
To program a One-Touch key
for DSS:
To use a DSS key:
SPK
DC
#
One-Touch
One-Touch
ICM
To Next Page
Loading...
