NEC Express5800 320La System Configuration Guide

2-4 Configuring Linux
3. Add the NICs of slot 7 to the VND list. Type:
vndctl add 7
4. Confirm the status. Type:
vndctl status 7
--Virtual Network Status--
virtual status config slot real(s)
ha0 OKAY yes 7 *epro01.06 epro09.06
Link encap:Ethernet HWaddr 00:00:4C:0F:F7:E0
BROADCAST MASTER MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
slot real status link
7 left epro01.06 DOWN
Link encap:Ethernet HWaddr 00:00:4C:0F:F7:E0
BROADCAST SLAVE MTU:1500 Metric:1
RX packets:4938 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:100
Interrupt:15 Base address:0x8000
right epro09.06 DOWN
Link encap:Ethernet HWaddr 00:00:4C:0F:F7:E0
BROADCAST SLAVE MTU:1500 Metric:1
RX packets:11135 errors:0 dropped:0 overruns:0 frame:0
TX packets:4086 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:100
Interrupt:21 Base address:0x3000
Referring to the above table, ha0 defines the two NICs as a duplex NIC,
listing them as a single NIC. The remainder of the table shows the set values
of the two actual NICs.
5. Configure the NICs of the duplex slot 7. Type:
vndctl config 7
6. Activate the NIC interface of the duplex slot 7. Type:
vndctl up 7

NEC Express5800 320La Specifications

General

Form Factor	Tower
CPU	Intel Xeon Processor
Storage	SCSI/SATA
Network	Integrated Ethernet
Operating System Support	Windows Server, Linux
Expansion Slots	6 total: 2 x 64-bit PCI, 2 x 32-bit PCI, 1 x shared PCI/ISA, 1 x ISA