8000 - Voice Mail
8003 - Voice Mail Port Options (Part 2)
212 ◆ Chapter 3: Programming IntraMail System Guide
8003 - Voice Mail Port Options (Part 2)
Description
Use the 8003 - Voice Mail Options (Part 2) to set trunk access for Voice Mail ports. The settings you make in
this option apply globally to all Voice Mail ports.
Options
Trunk Number
(LINE NUMBER)
Use this option to select the trunk you want to program. Trunk numbers are 1-6 in DS1000 and 1-64 in DS2000.
Options
■ Trunk number (1-6 in DS1000, 1-64 in DS2000)
Default
✔ N/A
Trunk Access Type
[N/A]
For the trunk selected above, use this option to select the access type. All Voice Mail ports use the access
type specified in this option for the selected trunk. A Voice Mail port can on dial out on a specific trunk only
if it is allowed in this option. This may occur when Voice Mail is processing Message Notification callouts.
You make a separate entry for each trunk.
■ See Message Notification on page 133.
Options
■ 0 (No access)
■ 1 (Incoming only)
■ 2 (Outgoing only)
■ 3 (Full access)
Default
✔ 3 (Full access)
8003 Program Entry
8003 - Voice Mail Options (Part 2) Program Entry
(Entry Range) [Default Setting]
ICM + #*#* + Password (372000) + HOLD + 8003 + HOLD.
LINE NUMBER (1-6 in DS1000, 1-64 in DS2000) [N/A]
Select Access Type (0=No Access, 1=Incoming Only, 2=Outgoing Only, 3=Full Access) [Full Access]
Press this: To do this:
HOLD
Enter (accept) data you entered.
CONF
Cancel your entry and back up to the previous prompt level.
VOL ▲ or Vol ▼
Scroll to the next prompt.
CHECK
Restore the previous entry.
To Next Page
Loading...