NEC IntraMail 4 - Mailbox Active; Options for Call Routing Mailboxes (1); Options for Announcement Mailboxes (2); Options for Subscriber Mailboxes (3)

8000 - Voice Mail
8005 - IntraMail Master Mailbox Options
IntraMail System Guide Chapter 3: Programming ◆ 219
3
■ 2 (Announcement)
■ 3 (Subscriber)
■ 4 (Directory Dialing)
■ 0 (Undefined)
Default
✔ 3 (Subscriber)
Mailbox Active
(MAILBOX ACTIVE)
Use this option to activate the selected mailbox. IntraMail can not use the mailbox unless it is active. See the
following for more:
■ Announcement Mailbox on page 22.
■ Call Routing Mailbox on page 49.
■ Directory Dialing on page 68.
■ Subscriber Mailbox on page 168.
Options
■ Y (Yes)
■ N (No)
Default
✔ Y (Yes)
Options for Call Routing Mailboxes (1)
The following options are available to Master Mailboxes assigned as Call Routing Mailboxes. For more on
each option, refer to 8006 - IntraMail Routing Mailboxes: Options for Call Routing Mailboxes on page 228.
■ Dial Action Table
■ Screened Transfer Timeout
■ Time Limit for Dialing Commands
■ Fax Detection
Options for Announcement Mailboxes (2)
The following options are available to Master Mailboxes assigned as Announcement Mailboxes. For more on
each option, refer to 8006 - IntraMail Routing Mailboxes:
Options for Announcement Mailboxes on page 229 .
■ Next Call Routing Mailbox
■ Repeat Count
■ Hang Up After
Options for Subscriber Mailboxes (3)
The following options are available to Master Mailboxes assigned as Subscriber Mailboxes. For more on
each option, refer to 1808 - IntraMail Subscriber Mailbox Options on page 202.
■ Number of Messages
■ Message Playback
■ Auto Erase/Save of Messages
■ Message Retention
■ Recording Conversation Beep
■ Message Waiting Lamp
■ Auto Attendant Do Not Disturb
■ Forced Unscreened Transfer
■ Auto Time Stamp
■ System Administrator
■ Alternate Call Routing Mailbox
■ Next Call Routing Mailbox