NEC MH240 - To Use a Headset; To Use Soft Keys; To Use While Charging

16
o TO USE A HEADSET
When a headset is inserted to the Headset
connector, your phone is in headset call mode.
- Connect a headset to the phone.
- When the phone receives a call, you can
hear ringing from the headset or speaker
(configurable). If vibration is set to enable,
it is also available.
- Press the key to answer the call.
- You can talk using the microphone and ear
phone of the headset.
- Press the key to end the call.
This phone has a JEAITA RC-5240
jack as a headset connector. If your
headset has an Ø2.5 plug, you can
connect the headset to the phone by
using a conversion cable.
Receiver and microphone do not
work when a conversion cable is
connected.
o TO USE SOFT KEYS
You will often use soft keys when you operate
this phone. You can use soft keys as follows.
o TO USE WHILE CHARGING
You can operate MH240 while charging as
following figure. But, the battery may become
empty when you talk for long time.
TIP
9/ 1 22:00 Eric
Incoming
8/31 10:03 Tom
Delete Save Back
8/31 10:12 Tom
9/ 1 9:25 222
TIP