NEC MH240 - Ntp Setting; Ntp Server

51
o NTP SETTING
Factory Default: Disable
You can use NTP server in your network as
required.
- Press the key while in Standby mode.
Your phone displays the main menu.
- Press the key to select “5.Setting” and
then press the key.
- Press the key to select “1.User Setting”
and then press the key.
- Press the key to select “7.Date & Time”
and then press the key.
- Press the key to select “5.NTP Setting”
and then press the key.
- Press the key to select “1.Disable” or
“2.Enable” and then press the “OK” soft
key.
Please confirm your network
administrator whether you can use
NTP Server.
You can reach the NTP Setting menu
by pressing the following keys.
To go to the NTP Setting menu:
o NTP SERVER
Factory Default: -
You can set a NTP server in your network as
required.
- Press the key while in Standby mode.
Your phone displays the main menu.
- Press the key to select “5.Setting” and
then press the key.
- Press the key to select “1.User Setting”
and then press the key.
- Press the key to select “7.Date & Time”
and then press the key.
- Press the key to select “6.NTP Server”
and then press the key.
- Edit an appropriate NTP Server Address (IP
or FQDN) and then press the “OK” soft
key.
Please contact your network
administrator to retrieve your NTP
Server Address.
You can reach the NTP Server menu
by pressing the following keys.
To go to the NTP Server menu:
TIP
NTP Setting
OK Back
1.Disable
2.Enable
TIP
TIP
time.xxxx.com
NTP Server
ab OK Clear
TIP