NEC NC1000C - Setting Up Your Projector - Overview; Setup Procedure Overview

31
2. Setting Up Your Projector
2-1. Setup Procedure
Set up the projector according to the procedure below. This chapter describes the installation of procedure until turning on of the
power.
• Step1
Projector Installation (See page 32)
• Step2
Selecting the Power Cable (See page 33)
Connecting the Power Cable (See Projector User’s Manual)
• Step3
Mounting the Lens Unit (See page 41)
• Step4
Mounting the Lamp (See Projector User’s Manual)
• Step5
Mounting the following optional parts as required.
- Installing the Media Block (NP-90MS02) (See page 44)