NEC NC1000C - Page 60

60
Projector Adjustment and Connecting
2
Remove the notch lter.
1. Loosen the screw on the notch lter until it is free to spin ( ). The screw does not detach
from the notch lter.
2. Gently pull up the notch lter and remove it ( ).
3
Take the dummy bracket from the accessory box.
4
Attach the dummy bracket.
1. Gently attach along the guides on the projector ( ).
Check that the position of the arrow on the dummy bracket is aligned with the arrow on the
projector.
2. Fasten the locking screws to affix the dummy bracket ( ).
Arrow