17
2. Installation and Connection
2-2. Connecting the Power Cable
The power cable is not included with the projector. Use a power cable that meets the standards and power supply voltage of
the country where you are using the projector. Ask your dealer for the power cable to select and purchase.
WARNING:
Carefully read the contents described in this section before connection and connect the cables according to the proper
procedure. Inappropriate handling may cause fatal, serious or other bodily injuries due to fire or electric shock.
CAUTION:
• Before connecting the power cables, check that the main power switch of the projector is turned off. Implement the con-
nection with AC power shut off.
• Be sure to ground the equipment to ensure safety. Use a power cable that meets the standards and power supply voltage
of the country where you are using the projector (page 78), and always connect the equipment to the ground. If the ground
is not connected, it may cause electrical shocks.
• When connecting the power cable plugs to the AC IN and the electrical outlet, securely insert the plugs all the way in. If
the connection between the power cable plug and the electrical outlet is loose, the plug area may generate heat, causing
burns and accidents.
• Switch the power cable and power supply voltage of the projector to match the projector to the voltage of the electrical
outlet you are connecting to. If selected incorrectly, it may cause damage or fires.
NOTE
• Install the electric outlet nearby the projector main unit so that the power supply can be cut by unplugging the
AC power cable.
• When plugging in or unplugging the AC power cable, make sure that the main power switch is pushed to the
[O] position. Failure to do so may cause damage to the projector.
• Do not use a three-phase power supply. Doing so may cause malfunction.
To Next Page
Loading...
Need help?
General
