NEC NC900C - Configuration

44
4. Using Menus
4-4. Conguration
Please request your dealer/distributor to perform the settings.
4-4-1. Lamp Setup
Adjust
Adjusts the lamp output (brightness).
← Displays the current output power value (%) when the lamp rated output is 100%.
← Displays the current power value (W).
Lamp Mode
Selects the lamp to use. When “Dual” is selected, lamp 1 and lamp 2 turn on/off at the same time. When “Lamp 1” or “Lamp
2” is selected, the other lamp is not used.
← Displays the currently selected item with asterisk (*).
← Displays the setting.
Dual Uses lamp 1 and lamp 2 at the same time.
Lamp 1 Uses only lamp 1 (lamp 2 is not used).
Lamp 2 Uses only lamp 2 (lamp 1 is not used).
TIP
• If you change the lamp mode while the lamp is on, the changed settings are applied immediately.
• If you change the lamp mode while the lamp is off, the changed settings are applied the next time the lamp is
turned on.
NOTE
When the lamp mode is changed, the LAMP ON/OFF button indicator blinks green (See page 67). You cannot
change the lamp mode while the LAMP ON/OFF button indicator is blinking. Wait until the LAMP ON/OFF button
indicator changes from blinking to steady on.