27
3. Projection of Images (Basic Operation)
3-3. Selecting the title of input signal
This projector allows you to select pre-registered title (input signal) using the preset buttons on the control panel (up to 16
titles). Request your dealer/distributor for details on registering and changing titles. This section explains the steps for select-
ing registered titles.
Turn on the power to the image devices connected to the projector.
Press the MENU button.
Press the LEFT/RIGHT button to display “Title Select” on the LCD screen.
At each press of the LEFT/RIGHT buttons, the display will cycle as “Title Select” ←→ “Configuration” ←→ “(Title
Setup)” ←→ “Information.”
Press the DOWN button.
The title of the input signal is displayed.
• When you have made a wrong selection, press the UP button. A return will be made to the previous menu.
Press the LEFT/RIGHT buttons to display “Title of Signal to be Projected” on the LCD screen.
Press the ENTER button.
The title of the signal to be projected is selected.
• The (*) mark on the LCD indicates that this is the currently selected item.
To Next Page
Loading...
Need help?
General
