32
3. Projection of Images (Basic Operation)
3-4-5. Adjusting the brightness of the projected screen (Lamp mode)
While the LAMP ON/OFF button indicator is blinking green (page 67), you cannot use the lamp mode settings
screen because the lamp mode cannot be set. Wait until the LAMP ON/OFF button indicator changes from blink-
ing to steady on.
Press the LAMP button.
The screen to adjust the lamp output is displayed.
Press the LAMP button while the lamp output adjustment screen is displayed.
The screen to select the lamp mode is displayed.
TIP
Press the ENTER button to switch the display between “Lamp Setup (Adjust)” and “Lamp Setup (Lamp Mode)”.
Press the LEFT/RIGHT button to select the lamp to use.
Dual Uses lamp 1 and lamp 2 at the same time.
Lamp 1 Uses only lamp 1 (lamp 2 is not used).
Lamp 2 Uses only lamp 2 (lamp 1 is not used).
Press the ENTER button.
• If the lamp is on, the changed settings are applied immediately.
• If the lamp is off, the settings are applied the next time the lamp is turned on.
NOTE
When the lamp mode is changed, the LAMP ON/OFF button indicator blinks green (See page 67). You cannot
change the lamp mode while the LAMP ON/OFF button indicator is blinking. Wait until the LAMP ON/OFF button
indicator changes from blinking to steady on.
To Next Page
Loading...
Need help?
General
