6. Using the VIEWER
101
5. Remove the USB memory from the projector.
NOTE:
• If you remove a USB memory from the projector without
executing [REMOVE USB DEVICE] in the menu, the operation
of the unit may become unstable. In that case, turn o the
power of the unit once and unplug the power cord from the
outlet.
Subsequently, wait for about 3 minutes before connecting
the power cord to the socket and turning on the power of
the unit.
USB
③ End the [VIEWER]
1. Press the MENU button in the slide screen or
le list screen.
A control bar or a pop-up menu will be dis-
played.
2. Press the MENU button again.
The [INPUT] screen is displayed.
3. Move the cursor to an input terminal other
than [USB-A] and press the ENTER button.
The [VIEWER] will end.
TIP:
• When using the remote controller, press the HDMI1 button etc. to end the [VIEWER].
To Next Page
Loading...
