23
2. Projecting an Image (Basic Operation)
8 Optimizing Computer Signal Automatically
Adjusting the Image Using Auto Adjust
Optimizing a computer image automatically. (Auto PC adj.)
Press the AUTO ADJ. button to optimize a computer image automatically.
This adjustment may be necessary when you connect your computer
for the first time.
[Poor picture] [Adjusted picture]
NOTE:
• Some signals may take some time to display or may not be displayed correctly.
• If the Auto Adjust operation cannot optimize the computer signal, try to adjust [Fine sync], [H position], [V position], and [H. size] manually.
(→ page 35, 36)
9 Turning Up or Down Volume
Sound level from the speaker or audio output can be adjusted.
Volume
Mute
Off
19
TIP: When no menus appear, the ◀ and ▶ buttons on the projector cabinet
work as a volume control.
When the above volume adjustment menu appears, press ▲ and ▼ buttons
to control the mute on and off.
NOTE:
• Volume control is available with the ◀ or ▶ button but invaild through
the remote control when an image is magnified by using the D-ZOOM
(+) button or when the menu is displayed.
• Volume control is not available with the ◀ or ▶ button when VIEWER
is used.
Increase volume
Decrease volume
To Next Page
Loading...
