NEC PH3501QL - Page 121

104
5. Using On-Screen Menu
DATEANDTIMESETTINGS
You can set the current time, month, date, and year.
NOTE:Theprojectorhasabuilt-inclock.Theclockwillkeepworkingforaboutamonthafterthemainpoweristurnedoff.Ifthe
mainpowerisoffforamonthormore,thebuilt-inclockwillcease.Ifthebuilt-inclockceases,setthedateandtimeagain.The
built-inclockwillnotceasewhileinthestandbymode.Inordertoactivatethebuilt-inclockcontinuouslyevenwhentheprojector
isnotused,leaveitinthestandbystatenotpluggingoffthepowercable.
TIME ZONE SETTINGS .............. Select your time zone.
DATE AND TIME SETTINGS
...... Set your current date (MM/DD/YYYY) and time (HH:MM).
INTERNET TIME SERVER: If you place a check mark, the projector’s built-in clock will be syn-
chronized with an Internet time server in every 24 hours and at the time of projector’s startup.
UPDATE: Synchronizes the projector’s built-in clock immediately. The UPDATE button is not
available unless the INTERNET TIME SERVER check box is turned on.
SUMMER TIME SETTINGS
....... If you place a check mark, the clock for daylight saving will be enabled.
DisablingtheCabinetButtons[CONTROLPANELLOCK]
ThisoptionturnsonorofftheCONTROLPANELLOCKfunction.
NOTE:
• Howtocancelthe[CONTROLPANELLOCK]
 Whenthe[CONTROLPANELLOCK]issetto[ON],presstheKEYLOCKbuttononthecabinetfor1secondorlongertocancel
the[CONTROLPANELLOCK]setting.
TIP:
• Whenthe[CONTROLPANELLOCK]isturnedon,akeylockicon[ ]willbedisplayedatthebottomrightofthemenu.
• ThisCONTROLPANELLOCKdoesnotaffecttheremotecontrolfunctions.
[NOTIFICATIONSETTINGS]
Thissettingistoenable/disable thenoticationbythebuzzerandrearLED(Lightstatusindicator/Systemstatus
indicator).
REARLED OFF [REARLED]isdeactivated.
ON The[REARLED]informsyouoftheunit’sstatusjustlikethestatusindicator.
BUZZER OFF Thebuzzergoesoff
ON Thebuzzerstops.
EnablingSecurity[SECURITY]
ThisfeatureturnsonorofftheSECURITYfunction.
Unlessthecorrectkeywordisentered,theprojectorcannotprojectanimage.(→page42)
NOTE:Yoursettingwillnotbeaffectedevenwhen[RESET]isdonefromthemenu.
SelectingCommunicationSpeed[COMMUNICATIONSPEED]
ThisfeaturesetsthecommunicationspeedforthePCControlport(D-Sub9P).Makesuretosettheappropriate
speed for the device to connect.
NOTE:
• Yourselectedcommunicationspeedwillnotbeaffectedevenwhen[RESET]isdonefromthemenu.