NEC PH3501QL - Using the Remote Control in Wired Operation

15
1. Introduction
Using the Remote Control in Wired Operation
ConnectoneendoftheremotecabletotheREMOTEterminalandtheotherendtotheremotejackontheremote
control.
REMOTE
Remote Jack
NOTE:
• WhenaremotecableisinsertedintotheREMOTEterminal,theremotecontroldoesnotworkforinfraredwirelesscommunication.
• PowerwillnotbesuppliedtotheremotecontrolbytheprojectorviatheREMOTEjack.Batteryisneededwhentheremotecontrol
isusedinwiredoperation.
• When[HDBaseT]isselectedinthe[REMOTESENSOR]andtheprojectorisconnectedtoacommercially-availabletransmission
devicethatsupportsHDBaseT,remotecontroloperationsininfra-redcannotbecarriedoutiftransmissionofremotecontrol
signalshasbeensetupinthetransmissiondevice.However,remotecontrolusinginfraredrayscanbecarriedoutwhenthe
powersupplyofthetransmissiondeviceisswitchedoff.