NEC PH3501QL - Page 24

7
1. Introduction
9. Connection terminals
 Variousimagesignalcablearetobeconnectedhere.(→page10)
10. AC input
 ConnectstotheACpowercable.TheACpowercableisnotanaccessory.Consultwithyourdealer/distributor
abouttheACpowercable.
11. Mountingholeforpowersupplycablestopper
 Attachtheenclosedpowercablestoppertopreventtheconnectorofthepowercablefromfallingout.
12.Projectorpowerswitch
 WhileACpowerisbeingsupplied,settheprojectorpowerswitchandlightpowerswitchtoONposition,thenyour
projector will enter a standby state.
13.Airinlet/Airlter
 Theairinletforcoolinginsidetheprojector.Donotcover.
 Anairlterisattachedovertheairinlettopreventdust.Referto“❸CleaningtheAirFilters”(→page124) on how
tocleantheairlter.
14.Lens(optional)
 Imagesareprojectedfromthelens.Requestyourdealer/distributortoinstallorreplacethelens.
15.RemoteSensor(locatedonthefrontandtherear)
(→page14)
NOTE:
•
Donotcovertheairinletsandoutletwhiletheprojectorisinoperation.Insufcientventilationleadstoariseoftheinternal
temperatureandmaycauseareormalfunction.