NEC PX2000UL - Adjustment Bar; Confirmation Message; Changing the Number

43
4. Using On-Screen Menu
4-1-2. Adjustment bar
To change the value on the adjustment bar, press the ◀/▶ button.
When you press the ◀/▶ button, the menu screen disappears and an adjustment bar is displayed at the bottom of
the screen.
Press the ◀/▶ button to adjust and MENU button to conrm.
4-1-3. Confirmation message
A conrmation message is displayed when you reset the adjustment value etc.
Press the ◀/▶ button to move the cursor to [OK] or [CANCEL], then press the ENTER button.
4-1-4. Changing the number
This section explains how to change the factory default IP address and subnet mask etc. in the network settings of
the menu.
1. Press the MENU button and select [SETUP] → [NETWORK SETTINGS].
The [NETWORK SETTINGS] screen is displayed.
2. Press the ▼/▲ button to move the cursor to the [IP ADDRESS], then press the ENTER button.
3. Press the ◀/▶ button to move the cursor to the value to change.
4. Press the ▼/▲ button to change the value, then press the ENTER button.
• Press the ▲ button to increase the value. Press the ▼ button to decrease the value.