NEC Univerge SV8100 - Page 1013

UNIVERGE SV8100 Issue 5.0
Transfer 1 - 1003
. With Transfer to Busy Extensions disabled (Program 24-02-02 = 0), you must also set Program 20-09-07
for the extensions COS to 0 to disable call queuing and Program 20-13-06 to set Automatic Off-hook
Signaling to manual.
 An existing call can be transferred into a conference call.
 Meet Me Paging Transfer allows the user to page a co-worker and have the call
automatically transferred when the co-worker answers the page.
 When transferring, an extension user can press a One-Touch key instead of dialing the
extension number.
 Serial calls allow for transferring a call so it automatically returns to the transferring
extension when completed.
 When a multiline terminal user is on a call, they can transfer to another station by pressing
a DSS key for that station. It is not necessary to press Transfer to transfer to another
station with a DSS key.
. When a multiline terminal user is on a call, they must press transfer to transfer a call off site with a DSS
key.
 A Trunk-to-Trunk transfer can be established by the following operation:
1. While talking to an outside party, press Hold.
2. Access a second outside line and dial the desired number.
3. Press Transfer to complete the Trunk-to-Trunk transfer.
. When the second call is to be transferred to another station (Not Trunk-to-Trunk), the user should press
Hold at step 3, then dial the desired station and press Transfer to complete the transfer.
 If station A calls Station B, and station A puts station B on hold and then calls station C,
station C cannot transfer the call.
Default Setting
Enabled
System Availability
Terminals
All Multiline Stations