NEC Univerge SV8100 - Table 1-7 Dial Tone Detection Program Interaction

Issue 5.0 UNIVERGE SV8100
1 - 374 Dial Tone Detection
Operation
Dial Tone Detection is automatic if enabled in programming.
21-01-06 System Options for Outgoing
Calls – Dial Pause at First Digit
If Dial Tone Detection is disabled,
the system waits based on this
time before sending dialed digits.
If using Dial Tone Detection, this
time should be set longer than the
time set in Program 21-01-05,
otherwise, if this time is set shorter
than Program 21-01-05, Dial Tone
Detection is satisfied and Program
21-01-05 is disregarded (not
used).
0~64800 (seconds)
(default = 1 second)
Table 1-7 Dial Tone Detection Program Interaction
Method 14-02-05 14-02-11
Result if dial tone
not present . . .
Press a line key
- or -
Dial 805+ Trunk
number
0 0 Trunk hangs (does not disconnect)
0 1 Trunk hangs (does not disconnect)
1 0 Trunk drops
1 1 Trunk drops
Dial a Trunk
Group code
- or -
Automatically
through a feature
0 0 Trunk hangs (does not disconnect)
0 1 Trunk reroutes after time-out
1 0 Trunk drops
1 1 Trunk reroutes after time-out
Program
Number
Program Name Description/Comments Assigned Data