Issue 5.0 UNIVERGE SV8100
1 - 606 Intercom
Handsfree Answerback/Forced Intercom Ringing:
20-17-01 Operator Extension – Operator’s
Extension Number
Define the extension numbers
which are to be used by operators.
Up to eight digits
(default = 101)
20-18-01 Service Tone Timers – Extension
Dial Tone Time
After getting Intercom dial tone, a
multiline terminal user has this
time to dial the first digit of the
Intercom call.
0~64800 (seconds)
(default = 30 seconds)
21-01-02 System Options for Outgoing
Calls – Intercom Interdigit Time
When placing Intercom calls,
users must dial each digit within
this time.
0~64800 (seconds)
(default = 10 seconds)
82-01-01
(01)
Incoming Ring Tone – Frequency
1
Customize the Intercom ring tone. 1 = 520Hz
2 = 540Hz
3 = 660Hz
4 = 760Hz
5 = 1100Hz
6 = 1400Hz
7 = 2000Hz
Default:
Refer to Table 1-12
Incoming Ringing Tone
on page 1-607
82-01-02 Incoming Ring Tone – Frequency
2
Customize the Intercom ring tone.
82-01-03 Incoming Ring Tone –
Modulation
Use this program to customize the
Intercom Ring Tone modulation if
desired.
0 = No Modulation
1 = 8Hz Modulation
2 = 16Hz Modulation
3 = Envelope
(default = 2)
Program
Number
Program Name Description/Comments Assigned Data
20-02-12 System Options for Multiline
Telephones – Forced Intercom
Ring (ICM Call Type)
Determine if an extension ICM
calls should be set as Forced
Intercom Ringing (1). If disabled
(0), Intercom calls
voice-announce. For all NEC
Cordless telephones, this option
must be set to “1” as voice
announce is not possible.
0 = Disable (Voice)
1 = Enable (Signal)
(default = 0)
20-06-01 Class of Service for Extensions Assign Class of Service (1~15) for
extensions.
Day Night/Mode: 1~8
Class of Service of
Extensions (1~15)
Default:
All extension port =
Class 1
Program
Number
Program Name Description/Comments Assigned Data
To Next Page
Loading...
