NEC Univerge SV8100 - Table 1-11 Extension Busy Setup

Issue 5.0 UNIVERGE SV8100
1 - 596 Hotline
20-13-06 Class of Service Options
(Supplementary Service) –
Automatic Off-Hook Signaling
(Automatic Override)
Program 20-02-03 and Program
20-13-06 set the conditions under
which a Hotline, Reverse Voice
Over or DSS Console key
indicates that an extension is busy.
With condition 1 in the following
chart, the BLF LED is on only
when both extension line
appearances are busy. In
conditions 2~4, the BLF LED is on
when one line appearance is busy.
0 = Off
1 = On
(default = 1 for
COS 1~15)
Refer to Table 1-11
Extension Busy Setup
on page 1-598
21-01-09 System Options for Outgoing
Calls – Ringdown Extension
Timer (Hotline Start)
A Ringdown extension
automatically calls its programmed
destination after this time.
0~64800
(default = 5)
21-11-01 Extension Ringdown (Hotline)
Assignment
Define the Hotline destination
number for each extension
number.
(maximum 24 digits)
0,
*, #, Pause, Hook
Flash, @ (Code to wait
for answer supervision)
(default not assigned)
22-01-01 System Options for Incoming
Calls – Incoming Call Priority
Use this option to determine if
Intercom calls or trunk calls have
answer priority when both are
ringing simultaneously.
0 = Intercom call
priority
1 = Trunk call priority
(default = 1)
30-05-02 DSS Console Lamp Table – Busy
Extension
Use to define the LED patterns for
busy extensions on the DSS
consoles.
0~7
[default = 7 (On)]
30-05-03 DSS Console Lamp Table – DND
Extension
Use to define the LED patterns for
DND extensions on the DSS
consoles.
0~7
[default = 3 (RW)]
30-05-04 DSS Console Lamp Table – ACD
Agent Busy
Use to define the LED patterns for
busy ACD agents function on the
DSS consoles.
0~7
[default = 7 (On)]
30-05-05 DSS Console Lamp Table – Out
of Schedule (ACD DSS)
Use to define the LED patterns for
out of schedule (ACD/DSS) on the
DSS consoles.
0~7
[default = 0 (Off)]
30-05-06 DSS Console Lamp Table – ACD
Agent Log Out (ACD DSS)
Use to define the LED patterns for
ACD agents that are logged out on
the DSS consoles.
0~7
[default = 5 (IL)]
30-05-07 DSS Console Lamp Table – ACD
Agent Log In (ACD DSS)
Use to define the LED patterns for
ACD agents that are logged in the
DSS consoles.
0~7
[default = 4 (IR)]
30-05-08 DSS Console Lamp Table – ACD
Agent Emergency (ACD DSS)
Use to define the LED patterns for
ACD agents in emergency on the
DSS consoles.
0~7
[default = 6 (IW)]
Program
Number
Program Name Description/Comments Assigned Data