NEC Univerge SV8100 - Table 1-30 Error Messages and Causes

Issue 5.0 UNIVERGE SV8100
1 - 1146 Voice Response System (VRS) Upload Download Audio
Guide to Feature Programming
Troubleshooting
The table below shows possible Error messages and Causes:
Program
Number
Program Name Description/Comments Assigned Data
90-02-01 Programming Password Setup –
User Name
Set the system passwords. Maximum 10
characters
Refer to the SV8100
Programming Manual
for default settings.
90-02-02 Programming Password Setup –
Password
Configure the administrator
accounts that are used when
connecting to the KTS via PCPro/
WebPro.
If using PCPro, these are the
accounts that are used to connect.
If using WebPro, these are the
accounts that are used to login.
. If calls are answered by an
Auto attendant first, instead
of the DIL setup on Program
22-01 and Program 22-07,
set the transfer destination in
the Auto Attendant to the
Modem Access Service
Code.
Up to eight digits.
Refer to the SV8100
Programming Manual
for default settings.
90-02-03 Programming Password Setup –
User Level
Set the system password user
levels.
0 = Prohibited User
1 = MF (Manufacturer
Level)
2 = IN (Installer Level)
3 = SA (System
Administrator Level 1)
4 = SB (System
Administrator Level 2)
5 = UA (User
Programming Level 1)
Refer to the SV8100
Programming Manual
for default settings.
Table 1-30 Error Messages and Causes
Error Message Cause
VMDB is not attached The PZ-VM21 is not attached.