NEC Univerge SV8100 - Table 1-24 Keys for Entering Names

UNIVERGE SV8100 Issue 5.0
Station Name Assignment – User Programmable 1 - 957
5. Press Hold.
6. Press Speaker to hang up.
To program any extension name:
1. Press Speaker.
2. Dial 800
- OR -
Press the Extension Name Change key (Program 15-07 or SC 851: 55).
3. Enter the extension number to be named.
4. Enter a name. (Refer to Table 1-24 Keys for Entering Names.).
. The name can be have to 12 digits maximum.
5. Press Hold.
6. Press Speaker to hang up.
Table 1-24 Keys for Entering Names
Use this keypad digit . . . When you want to. . .
1
Enter characters:
1 @ [ ¥ ] ^ _ ` { | }  ¨ Á À Â Ã Æ Ç É Ê ì ó
2
Enter characters: A-C, a-c, 2.
3
Enter characters: D-F, d-f, 3.
4
Enter characters: G-I, g-i, 4.
5
Enter characters: J-L, j-l, 5.
6
Enter characters: M-O, m-o, 6.
7
Enter characters: P-S, p-s, 7.
8
Enter characters: T-V, t-v, 8.
9
Enter characters: W-Z, w-z, 9.
0
Enter characters:
0 ! “ # $ % & ’ ( ) ô Õ ú
å ä ö ü α ε θ β
*
Enter characters:
* + , - . / : ; < = > ? B E σ S ∞ ¢ £
#
# = Accepts an entry (only required if two letters on the same key are needed
– ex: TOM). Pressing # again = Space. (In system programming mode, use
the right arrow Softkey instead to accept and/or add a space.)