NEC Univerge SV8100 - Page 966

Issue 5.0 UNIVERGE SV8100
1 - 956 Station Name Assignment – User Programmable
Guide to Feature Programming
Operation
To program your extension name:
1. Press Speaker.
2. Dial 800.
- OR -
Press the Extension Name Change key (Program 15-07 or SC 851: 55).
3. Press Hold.
4. Enter the name. (Refer to Table 1-17 Selectable Display Messaging Defaults on page 1-861.)
. Your name can be up to 12 digits maximum.
Program
Number
Program Name Description/Comments Assigned Data
11-11-22 Service Code Setup (for Setup/
Entry Operation) – Extension
Name Programming
Use to customize the extension
name programming used for
registration and setup.
MLT
(default = 800)
15-01-01 Basic Extension Data Setup –
Extension Name
Define the extension/virtual
extension name.
Up to 12 characters
Default:
STA 200 = Ext 200
STA 201 = Ext 201,
etc.
15-07-01 Programmable Function Keys Assign an Extension Name
Change key (55) to extensions.
Line Key 1~48
0~99 (Normal Function
Code 851 by default)
*00 ~ *99
(Appearance Function
Code) (Service Code
852 by default)
20-06-01 Class of Service for Extensions Assign a Class of Service (1~15)
to an extension.
Day Night/Mode: 1~8
Class of Service of
Extensions (1~15)
Default:
All extension port =
Class 1
20-13-21 Class of Service Options
(Supplementary Service) –
Extension Name
Turns Off (0) or On (1) an
extension user ability to program
its name.
0 = Off
1 = On
(default = 1 for
COS 1~15)