NEC Univerge SV8100 - Page 617

UNIVERGE SV8100 Issue 5.0
Intercom 1 - 607
20-08-10 Class of Service Options
(Outgoing Call Service) – Signal/
Voice Call
Turns Off or On an extension
allowing it to force Handsfree
Answerback or Forced Intercom
Ringing for outgoing Intercom
calls.
0 = Off
1 = On
(default = 1 for
COS 1~15)
20-09-05 Class of Service Options
(Incoming Call Service) – Signal/
Voice Call
Turn off or on an extension ability
to enable Handsfree Answerback
or Forced Intercom Ringing for
their incoming Intercom calls.
0 = Off
1 = On
(default = 1 for
COS 1~15)
20-13-06 Class of Service Options
(Supplementary Service) –
Automatic Off-Hook Signaling
(Automatic Override)
Allows a busy extension ability to
manually (0) or automatically (1)
receive Off-Hook Signals.
0 = Off
1 = On
(default = 1 for
COS 1~15)
80-01-01
(28)
Service Tone Setup – Tone 28
(Speaker Monitor Tone)
This tone changes the tone the
originator of an ICM call hears.
(The tone cannot be changed for
what is heard by the user when
receiving an ICM call.)
Refer to Service tones
(Service Tone #28).
80-01-02 Service Tone Setup – Basic Tone
Number
Use to define up to 64 Service
Tones. Each service tone is
defined by the combination of 32
Basic Tones.
1~33
(0 = No Tone)
(33=Default Time Slot).
82-01-01 Incoming Ring Tone – Frequency
1
Customize the Intercom ring tone. 1 = 520Hz
2 = 540Hz
3 = 660Hz
4 = 760Hz
5 = 1100Hz
6 = 1400Hz
7 = 2000Hz
Default:
Refer to Table 1-12
Incoming Ringing Tone
on page 1-607
Table 1-12 Incoming Ringing Tone
Incoming Ring
Tone Number
Tone
Type
Frequency 1 Frequency 2 Modulation
Pattern 1
(Trunk Incoming)
High
Mid
Low
1100
660
520
1400
760
660
16Hz Modulation
16Hz Modulation
16Hz Modulation
Program
Number
Program Name Description/Comments Assigned Data