NEC Univerge SV8100 - Page 618

Issue 5.0 UNIVERGE SV8100
1 - 608 Intercom
Operation
To place an Intercom call:
1. At multiline terminal, press Speaker.
- OR -
At single line telephone, lift the handset.
2. Dial extension number (or 0 for your operator).
. Your call may voice-announce or ring the called extension. Dial 1 to change the way your call alerts the called
extension.
. If the extension you call is busy or does not answer, you can dial another extension without hanging up.
To answer an Intercom call:
1. If you hear two beeps, speak toward telephone.
. Your telephone picks up your voice.
- OR -
If your telephone rings, lift the handset.
To check the extension data (multiline terminal only):
1. Press the Help key.
Pattern 2
(Trunk Incoming)
High
Mid
Low
1100
660
520
1400
760
660
8Hz Modulation
8Hz Modulation
8Hz Modulation
Pattern 3
(Trunk Incoming)
High
Mid
Low
2000
1400
1100
760
660
540
16Hz Modulation
16Hz Modulation
16Hz Modulation
Pattern 4
(Trunk Incoming)
High
Mid
Low
2000
1400
1100
760
660
540
8Hz Modulation
8Hz Modulation
8Hz Modulation
Intercom Incoming
Pattern
High
Mid
Low
1100
660
520
1400
760
660
8Hz Modulation
8Hz Modulation
8Hz Modulation
Alarm Sensor Pattern
High
Mid
Low
760
760
760
760
760
760
No Change
No Change
No Change
Table 1-12 Incoming Ringing Tone
Incoming Ring
Tone Number
Tone
Type
Frequency 1 Frequency 2 Modulation