NEC Univerge SV8100 - Page 1035

UNIVERGE SV8100 Issue 5.0
Trunk Groups 1 - 1025
15-07-01 Programmable Function Keys Assign function keys for trunk
group access (code
*02 + group)
or Call Appearance (CAP) Keys
(code
*08 + CAP Key orbit
0001~9999 (or 0000 for auto
assign).
Trunk Groups: 1~100
Line Key 1~48
0~99 (Normal Function
Code 851 by default)
*00 ~ *99
(Appearance Function
Code) (Service Code
852 by default)
15-13-01 Loop Key - Outgoing Used to define an outgoing loop
key
0~100(0 = Assigns
Loop Key to all Trunk
Groups
1~100 = Assigns Loop
Key to specified Trunk
Group
15-13-02 Loop Key - Incoming Used to define an incoming loop
key
0~100(0 = Assigns
Loop Key to all Trunk
Groups
1~100 = Assigns Loop
Key to specified Trunk
Group
20-02-02 System Options for Multiline
Telephones
– Trunk Group
Access Key Operating Mode
Set the operating mode of the
extension trunk group keys.
Operating Modes:
Incoming and Outgoing Access =
0
Outgoing Access = 1
Incoming Access = 2
0 = Outgoing /
Incoming
1 = Outgoing
2 = Incoming
(default = 0)
20-29-01 Timer Class for Extension – Day/
Night Mode 1~8, Class Number
Assign the timer class to each
extension. There are 16 Classes
that can be assigned. You make
eight entries for this Program, one
for each Night Service Mode. This
entry includes virtual extension
numbers.
0~15
0 = Not assigned
(default = 0)
20-31-04 Timer Class Timer Assignment –
Intercom Interdigits Time
(Intercom I/D Timer)
When placing Intercom calls,
extension users must dial each
digit in this time.
0~64800 (seconds)
(default = 10 seconds)
21-01-02 System Options for Outgoing
Calls – Intercom Interdigit Time
When placing Intercom calls,
extension users must dial each
digit in this time.
0~64800 (seconds)
(default = 10 seconds)
21-01-05 System Options for Outgoing
Calls – Disconnect Time When
Dial Tone Not Detected
If 14-02-11 is enabled, the system
skips over a trunk if dial tone is not
detected. This option pertains to
calls placed using Speed Dial,
ARS, Last Number Redial or Save
Number dialed. It does not pertain
to line key or Direct Trunk Access
calls.
0~64800 (seconds)
(default = three
seconds)
Program
Number
Program Name Description/Comments Assigned Data