NEC Univerge SV8100 - Page 1097

UNIVERGE SV8100 Issue 5.0
Voice Mail Integration (Analog) 1 - 1087
Guide to Feature Programming
Program
Number
Program Name Description/Comments Assigned Data
10-09-01 DTMF and Dial Tone Circuit
Setup
Assign at least one circuit for
DTMF reception (type 0 or 1).
Use the following as a guide when
allocating DTMF receivers:
In light traffic sites, allocate one
DTMF receiver for every 10
devices that use them.
In heavy traffic sites, allocate one
DTMF receiver for every five
devices that use them.
0 = Common Use
1 = Extension Only
2 = Trunk Only
Default:
Circuit/Resource
01~08 = 1 (Extensions)
Circuit/Resource
09~32 = 2 (Trunks)
Circuit/Resource
33~96 = 0 (Not Used)
Circuit/Resource
97~160 = 0 (Common)
When PZ-BS10 is
installed, 97~160 are
available
11-07-01 Department Group Pilot
Numbers – Dial
Assign a Department Group pilot
number for the Voice Mail (eight
digits maximum). The extensions
are assigned to the group in
Program 16-02-01.
Up to eight digits
(default not assigned)
11-11-50 Service Code Setup (for Setup/
Entry Operation) – Set Message
Waiting Indication
Assign a Service Code (eight
digits maximum) to set a Message
Waiting light from an Analog Voice
Mail port.
SLT
Up to eight digits
11-11-51 Service Code Setup (for Setup/
Entry Operation) – Cancel
Message Waiting Indication
Assign a Service Code (eight
digits maximum) to cancel a
Message Waiting light from an
Analog Voice Mail port.
SLT
Up to eight digits
15-02-26 Multiline Telephone Basic Data
Setup – MSG Key Operation
Mode
Determine whether an extension
MSG key should function as a
Message key (0) or Voice Mail key
(1) (Default = 0). If set as a
Message key, the user can press
the key to call the voice mail only
when they have new messages. If
set as a Voice Mail key, it functions
as a normal Voice Mail key.
0 = Message Key
1 = Voice Mail Key
(default = 0)
15-02-35 Multiline Telephone Basic Data
Setup – Message Waiting Lamp
Cycle for Calling Extension
This option allows you to select
the Message Waiting flash pattern
for the station that set the
Message Waiting reminder.
1 = Cycle 1
2 = Cycle 2
3 = Cycle 3
4 = Cycle 4
5 = Cycle 5
6 = Cycle 6
7 = Cycle 7
(default = 7)