NEC Univerge SV8100 - Page 110

Issue 5.0 UNIVERGE SV8100
1 - 100 Automatic Route Selection
Trunk Queuing/Camp On
Guide to Feature Programming
Program
Number
Program Name Description/Comments Assigned Data
11-01-01 System Numbering Set the system internal (Intercom)
numbering plan. The numbering
plan assigns the first and second
digits dialed and affects the digits
an extension user must dial to
access other extensions and
features, such as service codes
and trunk codes. If the default
numbering plan does not meet the
site requirements, use this
program to tailor the system
numbering to the site.
Refer to SV8100
Programming Manual
for a detailed
description of this
program.
11-09-01 Trunk Access Code Specify the digit or digits to be
used to access ARS (normally 9).
Dial up to four digits
(default = 9)
11-09-02 2nd Trunk Route Access Code Use this program to define
additional trunk access
codes.When a user dials the
Alternate Trunk Route Access
Code, the system routes their call
to the Alternate Trunk Route.
Dial up to four digits
(default not assigned)
12-01-01 Night Mode Function Setup –
Manual Night Mode Switching
Turn Off (0) or On (1) any
extensions from activating Manual
Night Service.
0 = Off
1 = On
(default = 1)
12-01-02 Night Mode Function Setup –
Automatic Night Mode Switching
According to a preset schedule,
enable (1) or disable (0) Automatic
Night Service for the system.
Make sure to set the Service
Patterns in Program 12-02-01,
Program 12-02-02 and Program
12-02-03.
0 = Off
1 = On
(default = 0)
12-02-01 Automatic Night Service
Patterns –Start Time
Define the daily pattern of the
Automatic Mode Switching. Each
Mode Group has 10 patterns.
These patterns are used in
Programs 12-03 and 12-04. The
daily pattern consists of 20 timer
settings.
This option defines the starting
time.
0000~2359
Refer to the SV8100
Programming Manual
for defaults.