NEC Univerge SV8100 - Page 1106

Issue 5.0 UNIVERGE SV8100
1 - 1096 Voice Mail Integration (Analog)
45-05-02 Voice Mail Send Protocol Signal
Without Additional Digits –
Direct Log-On
Use to send trunk number and/or
station number information if
integrating to Voice Mail when
Program 45-04-XX is left blank
and 45-01-15 is set to Program.
0:Off
1:On
(default = 0)
45-05-03 Voice Mail Send Protocol Signal
Without Additional Digits –
Transfer Message/QVM
Use to send trunk number and/or
station number information if
integrating to Voice Mail when
Program 45-04-XX is left blank
and 45-01-15 is set to Program.
0:Off
1:On
(default = 0)
45-05-04 Voice Mail Send Protocol Signal
Without Additional Digits –
Forward-All
Use to send trunk number and/or
station number information if
integrating to Voice Mail when
Program 45-04-XX is left blank
and 45-01-15 is set to Program.
0:Off
1:On
(default = 0)
45-05-05 Voice Mail Send Protocol Signal
Without Additional Digits –
Forward-Busy
Use to send trunk number and/or
station number information if
integrating to Voice Mail when
Program 45-04-XX is left blank
and 45-01-15 is set to Program.
0:Off
1:On
(default = 0)
45-05-06 Voice Mail Send Protocol Signal
Without Additional Digits –
Forward RNA
Use to send trunk number and/or
station number information if
integrating to Voice Mail when
Program 45-04-XX is left blank
and 45-01-15 is set to Program.
0:Off
1:On
(default = 0)
45-05-07 Voice Mail Send Protocol Signal
Without Additional Digits –
Remote Log-On
Use to send trunk number and/or
station number information if
integrating to Voice Mail when
Program 45-04-XX is left blank
and 45-01-15 is set to Program.
0:Off
1:On
(default = 0)
45-05-08 Voice Mail Send Protocol Signal
Without Additional Digits –
Conversation Recording
Use to send trunk number and/or
station number information if
integrating to Voice Mail when
Program 45-04-XX is left blank
and 45-01-15 is set to Program.
0:Off
1:On
(default = 0)
45-05-09 Voice Mail Send Protocol Signal
Without Additional Digits – Clear
Down String
Use to send trunk number and/or
station number information if
integrating to Voice Mail when
Program 45-04-XX is left blank
and 45-01-15 is set to Program.
0:Off
1:On
(default = 0)
80-03-01 DTMF Tone Receiver Setup –
Detect Level
Used to define the Detect Level for
DTMF Tone Receiver.
0 = 0dBm ~ -25dBm
1 = -5dBm ~ -30dBm
2 = -10dBm ~ -35dBm
3 = -15dBm ~ -40dBm
4 = -20dBm ~ -45dBm
5 = -25dBm ~ -50dBm
6 = -30dBm ~ -55dBm
(default: Type 1~5 = 0)
Program
Number
Program Name Description/Comments Assigned Data