NEC Univerge SV8100 - Page 1112

Issue 5.0 UNIVERGE SV8100
1 - 1102 Voice Mail Integration (Analog)
Operation
Calling your Mailbox
To call your mailbox:
Multiline Terminal
1. Press your Voice Mail key (Program 15-07 or SC 851: 77) or the Message key.
- OR -
Press Speaker and dial the Voice Mail Master Number. After Voice Mail Answers, dial your mailbox
number.
. Your mailbox number is normally the same as your extension number. You may optionally dial a co-worker’s
mailbox - or use this procedure to call your mailbox from a co-worker’s telephone.
2. If requested by Voice Mail, enter your security code.
. Ask your Voice Mail system administrator for your security code.
. Normally, your Message Waiting LED goes out (if applicable). If it continues to flash, you have unanswered
Message Waiting requests or a new General Message.
Single Line Telephone
1. Lift the handset and dial 717.
. If you are at a co-worker’s telephone, you can dial the Voice Mail master number and your mailbox number
instead. You can also use this procedure from your own telephone to call a co-worker’s mailbox.
80-04-08 Call Progress Tone Detector
Setup – OFF minimum time
Use to define the off minimum time
for the Call Progress Tone
Detector.
1~255 (30+30-
7680ms)
default:
Type 1 (DT) – 1 (60ms)
Type 2 (BT) – 12
(390ms)
Type 3 (RBT) – 52
(1590ms)
Type 4, Type 5 – 0
80-04-09 Call Progress Tone Detector
Setup – OFF maximum time
Use to define the off maximum
time for the Call Progress Tone
Detector.
0~255 (30+30-
7680ms)
default:
Type 1 (DT) – 1 (60ms)
Type 2 (BT) – 20
(630ms)
Type 3 (RBT) – 80
(2430ms)
Type 4, Type 5 – 0
Program
Number
Program Name Description/Comments Assigned Data