NEC Univerge SV8100 - Page 116

Issue 5.0 UNIVERGE SV8100
1 - 106 Automatic Route Selection
26-02-02 Dial Analysis Table for ARS –
ARS Service Type
For each Dial Analysis Table
(1~200), select 0 for no ARS, 1 for
Service Type 1 – Route to Trunk
Group Number to have the
number route to a trunk group
[Refer to Program 26-02-03] or 2
for Service Type 2 – F-Route
Selected to have the dialed
number controlled by the F-Route
table. If Service Type 2 is selected
and F-Route operation is on, the
F-Route table used is determined
by Program 44-04. If F-Route
operation is off, the routing is
determined by Program 44-05.
0 = No Service (None)
1 = Route to Trunk
Group
2 = Select F-Route
Access
(default = 0)
26-02-03 Dial Analysis Table for ARS –
Additional Data/Service Number
For each Dial Analysis Table
(1~200), if Service Type 1 was
selected in Program 26-02-02,
enter the trunk group number
(0~100, 0 = No Route).
If Service Type 1 (in
26-02):
Select Trunk Group
Number
(0~100, 0 = No Route)
If Service Type 2 (in
26-02):
F-Route Time
Schedule Not Used =
0~500
(F-Route Table
Number).
Refer to Program
44-05: ARS/F-Route
Table
F-Route Time
Schedule Used =
0~500 (F-Route
Selection Number).
Refer to Program
44-04: ARS/F-Route
Selection for Time
Schedule.
(default = 0)
26-02-04 Dial Analysis Table for ARS –
ARS Class of Service
For each Dial Analysis Table
(1~200), set the Automatic Route
Selection (ARS) Class of Service
(0~16).
0~16
(default = 0)
26-02-05 Dial Analysis Table for ARS –
Dial Treatment for ARS
For each Dial Analysis Table
(1~200), set the Automatic Route
Selection (ARS) Dial Treatment
(0~15) to be used.
0~15
(default = 0)
26-02-07 Dial Analysis Table for ARS –
Network Specified Parameter
Table
For each Dial Analysis Table
(1~200), set the Automatic Route
Selection (ARS) Network
Specified Parameter Table (0~16)
to be used.
0~16
(default = 0)
Program
Number
Program Name Description/Comments Assigned Data