UNIVERGE SV8100 Issue 5.0
Account Code Entry 1 - 13
Guide to Feature Programming
Program
Number
Program Name Description/Comments Assigned Data
14-01-11 Basic Trunk Data Setup –
Account Code Required
Enable (1) or disable (0) Account
Codes for each trunk.
0= Disable
1= Enable
(default = 1)
15-07-01 Programmable Function Keys Assign a function key as an
Account Code key (code 50). Use
this key instead of the dial pad to
enter the
* before and after the
Account Code.
Line Key 1~48
0~99 (Normal Function
Code 851 by default)
*00 ~ *99
(Appearance Function
Code) (Service Code
852 by default)
20-06-01 Class of Service for Extensions Assign a Class of Service (1~15)
to an extension.
Day Night/Mode: 1~8
Class of Service of
Extensions (1~15)
Default:
Extension port 101 =
Class 15
All other extension port
= Class 1
21-01-04 System Options for Outgoing
Calls – Dial Tone Detection Time
Adjust the interval the system
waits for the Telco to return Dial
Tone.
0~64800 (seconds)
(default = five seconds)
35-05-01 Account Code Setup – Account
Code Mode
Use this option to select the
Account Code Mode.
0 = Account Codes
Disabled (Codes
entered dial out as part
of initial call.)
1 = Account Codes
optional (not required).
2 = Account Codes
required but not
verified.
3 = Account Codes
required (forced) and
verified.
(default = 0)
35-05-02 Account Code Setup – Forced
Account Code Toll Call Setup
Enable Account Codes for all calls
or just toll calls (for mode 2 or 3 in
Program 35-05-01).
0 = Account Codes for
toll and local calls (All)
1 = Account Codes just
for toll calls (STD)
(default = 0)
35-05-03 Account Code Setup – Account
Codes for Incoming Calls
For each Class of Service (1~15),
enter 1 in this option to enable
Account Codes for incoming calls.
Enter 0 to disable Account Codes
for incoming calls. If disabled, any
codes you enter dial out on the
connected trunk.
0 = Account Codes for
incoming calls disabled
(No)
1 = Account codes for
incoming calls (Yes)
(default = 0)
To Next Page
Loading...
