NEC Univerge SV8100 - Features

UNIVERGE SV8100 Issue 5.0
Account Code Entry 1 - 15
If your system has Verified Account Codes enabled, be sure to choose a code programmed into your
Verified Account Code list.
1. Access trunk for outside call.
. You can press a line key or dial a code (except 9) to access a trunk. Refer to Central Office Calls, Placing on
page 1-245 for more information.
2. Dial *.
- OR -
Press your Account Code key (Program 15-07 or SC 851: code 50).
3. Dial your Account Code (1~16 digits, using 0~9 and
#).
. If you make an incorrect entry, your system may automatically alert the operator. If Account Codes are hidden,
each digit you dial shows an
* on the telephone display.
4. Dial *.
- OR -
Press your Account Code key (Program 15-07 or SC 851: code 50).
5. Dial the number you want to call.
To enter an Account Code for an incoming call:
This procedure is not available for single line telephones.
1. Answer incoming call.
. If Account Codes for Incoming Calls is disabled, the following steps dial digits out to the connected trunk.
2. Dial *.
3. Enter the Account Code.
. You can enter any code of the proper length. Incoming Account Codes cannot be Forced or Verified.
4. Dial *.
To enter an Account Code at a single line telephone:
1. Access trunk for outside call.
. You can access a trunk by dialing a code. Refer to Central Office Calls, Placing for more information.
2. Dial *.
3. Enter Account Code (1~16 digits).
4. Dial
*.
5. Dial number you want to call.