NEC Univerge SV8100 - Page 307

UNIVERGE SV8100 Issue 5.0
Code Restriction In Credit 1 - 297
21-06-02 Toll Restriction Table Data Setup
– International Call Permit Code
Table
Enter the international dialing
codes you want to permit.
Dial (Up to six digits)
Default:
Tables 1~20 = No
Setting
21-06-03 Toll Restriction Table Data Setup
– Maximum Number of Digits
Table Assignment
Select the maximum number of
digits allowed in outgoing calls for
each table (4~30).
4-30
default:
Tables 1~ 4 = 30
21-06-04 Toll Restriction Table Data Setup
– Common Permit Code Table
Program codes into the Common
Permit Code Table.
Dial (Up to four digits)
default:
Table 1 ~ 10 = No
Setting
21-06-05 Toll Restriction Table Data Setup
– Common Restriction Table
Program codes into the Common
Restrict Code Table.
Dial (Up to 12 digits)
default:
Tables 1~ 10 = No
Setting
21-06-06 Toll Restriction Table Data Setup
– Permit Code Table
Program codes into the Permit
Code Tables.
Dial (Up to 12 digits)
default:
Table 1~4 = No Setting
21-06-07 Toll Restriction Table Data Setup
– Deny Restriction Table
Program codes into the Restrict
Code Tables (200 codes per table
maximum).
Dial (Up to 12 digits)
default:
Table 1~4 = No Setting
21-06-08 Toll Restriction Table Data Setup
– PBX Access Code
The system allows up to four
tables for PBX access codes.
PBX Access Codes can have up
to two digits, using 0~9,
#, * and
LINE KEY 1 (don’t care). Refer to
the PBX Compatibility feature for
the specifics.
Dial (Up to two digits)
default:
Table 1~4 = No Setting
21-09-01 Dial Block Setup – Toll
Restriction Class with Dial Block
Assign a Code Restriction COS
(1~15) when the Dial Block feature
is used.
1~15
(default = 15)
21-09-02 Dial Block Setup – Supervisor
Password
Assign a 4-digit password to be
used by the supervisor to enable
or disable Dial Block for other
extensions.
0~9, *, #
(4-digit fixed)
(default not assigned)
21-10-01 Dial Block restriction Class per
Extension
Assign the Code Restriction COS
(1~15) to be used by an extension
when the Dial Block feature is
enabled. If this data is “0”, Code
Restriction COS follows Program
21-09-01.
0, 1~15
(0 = No Setting)
(default = 0)
90-19-01 Dial Block Release Enter the extension number to be
released from the Dial Block
Restriction. This program can be
used when a password is forgotten
by the user.
[Release?]: Dial 1+
press Transfer
(Press Hold to cancel.)
Program
Number
Program Name Description/Comments Assigned Data