NEC Univerge SV8100 - Page 334

Issue 5.0 UNIVERGE SV8100
1 - 324 Conference, Remote
Guide to Feature Programming
Program
Number
Program Name Description/Comments Assigned Data
11-19-01 Remote Conference Pilot
Number Setup - Maximum
Channels
Assign the pilot number (up to 8
digits) to be used for the Remote
Conference. This is the number
that outside parties will call in
order to connect to a conference.
Dial (Up to 8 digits)
(default: No Remote
Conference Pilot
Numbers assigned to
any Conference Group
(1-4).)
14-01-02 Basic Trunk Data Setup –
Transmit Level
The option sets the amount of
transmit gain (signal amplification)
for the trunk being programmed.
Trunks 1~200
1~63
(-15.5 ~ +15.5dB in
0.5dB intervals)
[default = 32 (0dB)]
14-01-03 Basic Trunk Data Setup –
Receive Level
The option sets the amount of
receive gain (signal amplification)
for the trunk being programmed.
Trunks 1~200
1~63
(-15.5 ~ +15.5dB in
0.5dB intervals)
[default = 32 (0dB)]
14-01-04 Basic Trunk Data Setup –
Transmit Gain Level for
Conference and Transfer Calls
The option sets the amount of
transmit gain (signal amplification)
for the trunk being programmed
when it’s part of an Unsupervised
Conference or transferred.
1~63(-15.5dB ~
+15.5dB in 0.5dB
intervals)
[default = 32 (0dB)]
14-01-05 Basic Trunk Data Setup –
Receive Gain Level for
Conference and Transfer Calls
The option sets the amount of
receive gain (signal amplification)
for the trunk being programmed
when it’s part of an Unsupervised
Conference or transferred.
1~63(-15.5dB ~
+15.5dB in 0.5dB
intervals)
[default = 16 (-8dB)]
14-02-09 Analog Trunk Data Setup – Busy
Tone Detection
Enable (1) this option to allow
analog trunks which can not detect
disconnecting to be
released at the end of the
conference.
0 = Disable
1 = Enable
(default = 0)
20-13-46 Class of Service Options
(Supplementary Service) –
Remote Conference
For each Class of Service (01-15),
determine whether an extension
should be able to place an
intercom call to join a Remote
Conference call.
0 = Off
1 = On
(default = 1 for
COS 1~15)
20-34-01 Remote Conference Group
Setup - Conference Name
For each conference group, enter
the name (up to 12 characters)
displayed at the time of a Remote
Conference. This entry will display
on the keyset LCD.
Maximum 12
characters
(default:
Group1 - Conf 1
Group2 - Conf 2
Group3 - Conf 3
Group4 - Conf 4)