NEC Univerge SV8100 - Page 343

UNIVERGE SV8100 Issue 5.0
Continued Dialing 1 - 333
Guide to Feature Programming
Operation
To use Continued Dialing:
1. Place an intercom or trunk call.
Program
Number
Program Name Description/Comments Assigned Data
15-03-03 Single Line Telephone Basic
Data Setup – Terminal Type
Enter 1 for this option to allow a
single line port to receive DTMF
tones after the initial call setup.
Enter 0 to have the port ignore
DTMF tones after the initial call
setup. For Voice Mail, always
enter 1 (e.g., receive DTMF
tones).
0 = Normal
1 = Special
(default = 0)
20-06-01 Class of Service for Extensions Assign a Class of Service (1~15)
to extensions.
Day Night/Mode: 1~8
Class of Service of
Extensions (1~15)
Default:
All extension port =
Class 1
20-13-13 Class of Service Options
(Supplementary Service) –
Continued Dialing (DTMF) Signal
on ICM Call
Turn Off (0) or On (1) the
extension ability to use Continued
Dialing, which allows DTMF signal
sending while talking on
extension.
0 = Off
1 = On
(default = 1 for
COS 1~15)
21-04-01 Toll Restriction Class for
Extensions
Assign a Toll Restriction Class
(1~15) to an extension.
Day/Night Mode
1~9 (9 = Power Failure
Mode)
1~15
(default = 2)
21-05-04 Toll Restriction Class –
Maximum Number of Digits Table
Assignment
Select the table (defined in
Program 21-06-03) to be used to
determine the maximum number
of digits allowed for outgoing calls.
1~4 =Table
0 =Disable (None)
Default:
1, 2, 6~15 = 0
3 = 1
4 = 2
5 = 3
21-06-03 Toll Restriction Table Data Setup
– Maximum Number of Digits
Table Assignment
Set the Maximum Number of digits
dialed for each table.
4-30
default:
Tables 1~4 = 30