UNIVERGE SV8100 Issue 5.0
Alarm Reports 1 - 25
Conditions
z Alarm Reports and System Information Reports can be output to a USB stick on the
CD-CP00.
z The UNIVERGE SV8100 supports the following Alarms to be output to the LCD of a
multiline terminal:
o SMDR Buffer Full
o CD-CP00-LAN link Error
z The UNIVERGE SV8100 does not support printouts of the following Alarms:
o Power Failure
o RAM Backup Battery Error
o Networking Keep Alive Error
z Up to 12 System Alarm times can be scheduled to print on a Monthly, Daily, and Hourly time
frame. The report indicates both Major and Minor Alarms.
z System Information Reports cannot be set to output at a scheduled time.
z When using the E-mail functionality of reports, the E-mail address in Program 90-11-10
(From Address) must be set for the E-mail feature to work.
z Once output of new alarms is performed, these same alarms are not output a second time.
New alarms must be generated before Program 90-12-04 can be performed a second time.
z Up to 100 System Alarm Reports can be stored. When the buffer fills, the oldest record is
17 3-1 none Not Install
18 3-2 none Not Install
19 3-3 none Not Install
20 3-4 none Not Install
21 3-5 none Not Install
22 3-6 none Not Install
23 3-7 none Not Install
24 3-8 none Not Install
Table 1-4 Sample System Information Printout (Continued)
System Information 05/18/2006 11:02
slot location type assign port condition note
To Next Page
Loading...
