NEC Univerge SV8100 - Page 411

UNIVERGE SV8100 Issue 5.0
Direct Inward Dialing (DID) 1 - 401
Operation
DID calls ring extensions like normal trunk calls.
To Activate DID Call by Time Schedule:
1. At any display multiline terminal, press Speaker.
2. Dial the Dial-In Mode Switching Service Code (Default = Not assigned).
- OR -
Press the Dial-In Mode Switching Programmable Function key (Program 15-07-01, 88, or SC 851
Key Code 88).
3. Dial 1~100 (table number).
22-11-02 DID Translation Number
Conversion – Target Number
For each DID Translation Table
entry (1~2000), specify the
extension the system dials after
translation.
. Do not assign Received
Digits in PRG 22-11-01 when
using DID Call by Time
Schedule.
Maximum 24 digits
(default not assigned)
22-17-01 Dial-In Conversion Table Area
Setup for Time Pattern –
Received Dial
Use to define the received
numbers for each Dial-In
Conversion Table (Program
22-17-02, 22-17-03 and
22-17-04).
Up to eight digits
(default not assigned)
22-17-02 Dial-In Conversion Table Area
Setup for Time Pattern – Start of
Time
Use to define the Starting Time for
each DID Translation table in
Program 22-17-01.
0000~2359
(Time)
(default = 0000)
22-17-03 Dial-In Conversion Table Area
Setup for Time Pattern – End of
Time
Use to define the Ending Time for
each DID Translation table in
Program 22-17-01.
0000~2359
(Time)
(default = 0000)
22-17-04 Dial-In Conversion Table Area
Setup for Time Pattern – Dial-In
Conversion Table
Number
Used to assign each time pattern
to a DID Translation Table Entry in
Program 22-11.
0~2000
(default = 0)
Program
Number
Program Name Description/Comments Assigned Data