NEC Univerge SV8100 - Page 432

Issue 5.0 UNIVERGE SV8100
1 - 422 Direct Inward System Access (DISA)
Trunk Continue/Disconnect Codes
25-12-01 Alternate Trunk Group Routing
for DISA
Assign the trunk route that DISA
Callers access if they dial the
Alternate Trunk Route Access
Code. Refer to Central Office
Calls, Placing on page 1-245 for
more information on setting up
Alternate Trunk Route Access.
Day/Night Mode = 1~8
Route Table Number =
0~100
(0 = No Setting)
(default = 1)
Program
Number
Program Name Description/Comments Assigned Data
14-01-25 Basic Trunk Data Setup –
Continued/Discontinued
Trunk-to-Trunk Conversation
When Program 24-02-10 is set to
disconnect a trunk after the
defined time, determine whether
or not a user should have the
ability to use the continue/
disconnect code.
0 = Disable (No)
1 = Enable (Yes)
(default = 0)
22-07-01 DIL Assignment Assign the master/pilot number of
the voice mail group from Program
11-07-01 as the DIL destination. If
all Voice Mail ports are in the
same unique Extension
(Department) Group (see Program
16-02 above), the DIL rings
another Voice Mail port if its
assigned port is busy.
Extension Number
(maximum eight digits)
(default not assigned)
20-28-01 Trunk to Trunk Conversation –
Conversation Continue Code
When Program 14-01-25 is
enabled, determine the 1-digit
code the user should dial (0~9,
*,
#) to extend the conversation for
the time defined in Program
20-28-03. If the Continue and
Disconnect codes are
programmed the same (e.g.,
#),
the system follows the "Continue"
operation. Using the Continue
code before the warning tone is
heard has no action.
0~9, #, *
(default not assigned)
20-28-02 Trunk to Trunk Conversation –
Conversation Disconnect Code
When Program 14-01-25 is
enabled, determine the 1-digit
code the user should dial (0~9,
*,
#) to immediately disconnect their
call. Using the Disconnect code
before the warning tone is heard
disconnects the call.
0~9, #, *
(default not assigned)
Program
Number
Program Name Description/Comments Assigned Data